Average Reviews:
(More customer reviews)This tool is a compete piece of junk. What was I expecting for $10? Don't waste your time.
On one of the cutter assemblies the hole that clamps onto the cross bar was machined oversize so it was just barely possible to tighten the socket screw enough to hold it firmly in place on the cross bar. After a little use I could not tighten the screw enough to hold the cutter assembly in place.
After cutting one hole the cross bar that holds the cutter developed play where it fits into the center mandrill. This allows the cutters to chatter badly.
There is a safety nut on each end of the cross bar the keeps the cutter assemblies from spinning off should they become loose. Both safety nuts keep loosening and falling off. There is no lock washer so of course these are going to vibrate loose. If this was the only problem you could install your own lock washer.
Click Here to see more reviews about: Steelex D2251 Adjustable Circle Cutter
Bore holes from 1" to 5" on your drill press with this Adjustable Circle Cutter. Made of M-2 alloy steel, this circle cutter features 3/8" hex shank, 5/16" drill, center point and Allen® wrench.
Click here for more information about Steelex D2251 Adjustable Circle Cutter
0 comments:
Post a Comment