Average Reviews:
(More customer reviews)I use these with a power carver. These burrs hog off wood with no finesse or grace, just brute cutting. They get the job done. Expect to have to clean up the carving area with sandpaper as a rasp leaves scratches. I've used several of the ten burrs, they do what they are designed to do and they are holding up well. HOWEVER, be aware that these are 1/8 inch shafts. But when you put the burr into a 1/8 collet, it doesn't fit as it's too big by a hair. I think its because of the heavy coating they have. I just gave it a quick tour of a fine-grit stone and removed the coating. Then they fit the collet just fine. If you use these burs with a power carver e.g. Wecheer or Fordome, be aware these burrs aren't designed to 15,000 to 30,000 rpm. So keep it in the under 10K range. With the coarsness of these burrs, you will not use anywhere near what is considered high speed....unless you are just trying to disintegrate a board.
A good, inexpensive option for the times you need to rough out wood, etc.
Click Here to see more reviews about: 10 High Speed Black Carbon Rasp Burr Wood Working Rotary Tool Bits Set for Dremel
0 comments:
Post a Comment