Average Reviews:
(More customer reviews)This attachment allows the Black & Decker RTX to become a much more useful tool. It also allows for more precise control because you will have better places to put your hands.
The instructions use pictures to illustrate fitment. I found the visual representations confusing - a few words would have made the job far easier.
Nevertheless there are not that many parts and you should be able to figure out how to install your 90 degree attachment.
The one problem that I had was that the collet from the RTX didn't fit into the Roto 90's business end.
I used an 11/64ths bit in a cordless drill to carefully ream the receiver. That solution worked perfectly.
There is a 1/8 locking hole built into the Roto 90 that should be used for tightening the collet instead of relying on the RTX's shaft lock.
The drag created by the 90 does cause the RTX to run hotter. If you feel that your RTX is becoming too hot - stop working and allow it to cool down.
When in operation this attachment is worthy of 5 stars -
Issues with fitment forced me to subtract 1 star.
caslo
Click Here to see more reviews about: Milescraft 1008 Roto 90 Right Angle Attachment
MilesCraft 1008 Roto90 Right Angle Attachment. Get around corners and into tight spaces with your rotary tool. Includes adaptors to fit most rotary tools. 3 Sets of ball bearings and special gearing provides long lasting and smooth operation. Coupling system allows you to rotate and position the attachment on your tool. Quick connect system attaches to your rotary tool without tools. Compact design fits almost anywhere. Includes collet nut and square drive not, but does not include any collets. Uses standard Dremel sized collets. Rotary tool not included. For use with most Corded Dremel, Black and Decker RTX, Co/Tech, King Craft, Budget, Maxicraft, Einhell, Wetekom, and Skil Small Rotary tools.
Click here for more information about Milescraft 1008 Roto 90 Right Angle Attachment
0 comments:
Post a Comment